Genesis Advanced Technologies 2006 Manuale Utente

USER’S MANUAL GENESIS 2002 TM GENESIS 2006 TM PLASMA THAWING WATER BATH SYSTEM GenesisBPS, LLC 65 Commerce W

5. TO CLEAN THE BATH OR TO ADD WATER SAFETY : NEVER ADD WATER OR MOVE THE BATH IF THE POWER SWITCH (ON THE LEFT SIDE PANEL)

when filled with water. Do not drop the bath on a hard surface. GENESIS 2006: Remove all, or part of the water. The bath weighs approximately

6. CONTROL PANEL AND INDICATORS GENESIS 2002TM CONTROL PANEL 12

GENESIS 2006TM CONTROL PANEL 13

CONTROL KEYS POWER ... This key turns the unit on and off when the POWER SWITCH on the left panel is turned ON. The POWER S

INDICATORS HEATING ... This red indicator is lit when the heating element is actually drawing current from the circuit and hea

2) The ADD WATER light is on and there is sufficient water in the bath. • With the unit unplugged and raised out of the water, check that

7) Pump does not circulate the water. • Debris may be in the pump impeller housing. Raise the shroud unit and lock in the up position.

8. SPECIAL FEATURES • Thaws multiple plasma units simultaneously • Thaws standard size plasma as well as cryoprecipitate • Individual time settin

10. SPECIFICATIONS GENESIS 2002TM GENESIS 2006TM External Dimension 21.6” L x 8.3” Wide x 13.2” High 26.6” L x 9.6” Wide x 13.2” H

GENESIS 2006 SHOWN 2

11. ORDERING/RETURN INFORMATION ORDERING INFORMATION : To place an order for a part or an accessory, please call : GenesisBPS, LLC 6

Hospital/Account Name Department and shipping address Name and telephone number of contact Date GENESIS 2002/2006

GENESIS 2002 GENESIS 2006 PLASMA THAWING WATER BATH SYSTEM WARRANTY The GENESIS 2002/2006, Plasma Thawing Water Bath System is warranted a

To assure proper record keeping, please retain this information for future use. DATE PURCHASED ____________________________ SERIAL # __________

CONTENTS page 1. UNPACKING ... 5 2. TO THAW BLOOD PROD

1. UNPACKING 1.1 The following is supplied with your GENESIS 2002/2006 unit. Control Unit Water Bath Thawing B

indicator will light. To correct this situation, fill bath with water as explained above. Add 2 ml of LABath CLEANTM each time the water is ch

c. To change the default SET TEMP : You can adjust this temperature within the range of ambient to + 56 °C, in one degree increments. To adjust, p

thawing time may vary. The amount of air left in the plasma thawing bag during thawing will also affect thawing time. The laboratory personnel ca

3. TO REMOVE A THAWED BAG 3.1 Press the ROCK key to stop the rocking motion. a. Remove the thawed bag (and any weights used) from the P